Day 96 (August 30, 2010)

Mock up engine was removed. 

Additional holes were drilled into the pedal. Each hole, at a different radius from the pivot point, changes the amount of force required to push the pedal a given distance. The ratios, for output force to input force, are 4.82:1, 5.59:1, 7.38:1, and 8.85:1. 

Removed and painted steering components.

Day 97 (August 31, 2010)

Checked springs on engine.

Day 98 (September 2, 2010)

Pulled heads from engine.

Day 99 (September 3, 2010)

Dropped heads off at Ben’s. Added 0.015” shims to 4 springs. 

Day 100 (September 4, 2010)

Pulled short block and transmission from coupe. 

Installed heads with 7.95” push rods on exhaust and 1 intake. 

Set engine into car and mocked up exhaust. 

Fabricated and welded into place 6 seat mounts. Started cell mount. (3 pieces) 

Make a Free Website with Yola.